Flow Meter Tokico 3 Inch and Adjuster


Tokico oil flowmeters are positive displacement type flow meter which are used in a wide variety of applications including measuring of boiler fuel oil and diesel oil, as well as for transactions for kerosene, light oil and heavy oil.

FRO Type

This flowmeter is widely used for transaction and in other applications is which a Roots type flowmeter is most suitable.

The Roots rotor rotates without physical contact, resulting in extremely low pressure loss. In addition, its accuracy remain virtually unchanged over a long period of time.

 

Features :

  • Wide flow range and high accuracy

The accuracy of these flowmeters is within ±0.5% over a wide range of flow rates (max range of 1 : 150 for heavy oil)

  • Small pressure loss

Because the pressure loss of these meters is low, it is possible to perform accurate measuring at the suction side of a pump as well as accurate measurement of high viscosity fluids.

  • Compact Design

A positive displacement type flowmeter can be used at relatively high rotating speeds, making for compact design. In addition, the counter unit of these meters is compact yet easy-to-read, and construction is simple.

  • Excellent durability

The simple construction of these meters makes for longterm durability with virtually no degradation of accuracy

  • An electrical transmitter Unit attachable

A microswitch or a reed switch type transmitter unit having simple construction and high reliability is available.

 

Specification Product Flowmeter with Accuracy Adjuster

Applicable Fluid : Petroleum, Petrochemical, etc

Accuracy : ±0.5%

With accuracy adjuster : ±0.2%

Flow rate range : 0.004~160m3/h

Fluid Temperature :

-5~150°C

(50°C is Max. In case of roots material AC7A

150°C is ax. In case of FC200

Max. working pressure : Max, 2.5 MPa (25kgf/cm²)

Fluid Viscosity : Max. 150,000mPa s (150,000cP)

Connection Size : 25mm (1B) ~ 100mm (4B)

Flange rating

FC 2 5 0 : JIS 10K FF

FCD400 : JIS 10K FF

SC PH 2 : (JIS 10K, 20K RF ANSI JP11500, 300 RF)

Material

Main Body :

FC 2 5 0 : (capacity 35-52 type)

FCD400 : (capacity 35-41 type)

SC PH 2 : (capacity 35-52 type)

Rotor : FC200, AC7A or ADC

Rotor Shaft : SUS416 hard chrome plating

Bearing : C5191, FC, Ball bearing

Driving Gear : SUS 420J2

Piping Installation : Horizontal or vertical piping

Have any Question or Comment?

Leave a Reply

Your email address will not be published. Required fields are marked *